How to install your wardrobe doors
This is a step by step guide to installing your wardrobes
Measure the width of the top of your opening. Using a set square mark a straight line across the Top Track A. Measure the width of the base of your opening. Mark a orresponding line across the bottom track B. Then cut the tracks using a fine tooth hacksaw.
Top Track – Position track into the top of the opening. Drill and plug the header/ceiling as required and fix top track.
Floor track – Position the track 32mm back from the front line of the top track. Fix the floor track using double sided tape or screws. IMPORTANT- Floor track should never be raised on a plinth as this could lead to doors leaving the tracks.
Tip – If installing Panel doors in combination with mirror doors it is usual to locate the panel doors to the back and mirror doors to the front of the track
Always locate the back door first. Install doors with the bottom of the door slanting out at 15 degree. Lower bottom wheels into bottom track before engaging top guides.
Engaging top guide:
Push up the white plastic section of the guide to engage into top track. To remove door from top track pull down on top guide as shown. Guide will then disengage from top track. Lift out at a 15 degree angle.
Align doors plumb to side walls. Adjust bottom wheel to alter the height and angle of each door. Using a pozidrive screwdriver, correct door alignment with screw adjuster attached to bottom wheel. Turn the screw clockwise to lower the door. Plumb doors to adjacent walls and other doors by adjusting both left and right wheels up and down as required.
Engaging ant jump clips:
A Rotate anti-jump clip into open position
B Push anti-jump clip fully down into track
c Rotate anti-jump clip back into closed position